|
|
Oil capacity
Oil level checking procedure
Torque Specifications
|
Oil capacity |
|
|
|
Oil level checking procedure |
 |
 |
 |
 |
| Park vehicle on level surface to check the oil level | |||
| Check the transmission for leaks before checking the oil level | If oil loss is severe, determine and eliminate cause. | ||
| Open locking lever (6a) | Up to 09/93 (illustration 1) | ||
| Press locking pin (6b) to one side in direction of arrow, remove both parts and open locking lever (6a) | As of 10/93 (illustration 2) | ||
| Pull out dipstick (6) | Wipe off with fluff-free cloth | ||
| Insert oil dipstick (6) up to the stop, pull out again and read off oil level. | When the transmission is cold, (transmission oil temperature
approx. 30 deg C) the display must be between the "min" and "max" marks for the
correct oil level (illustration 4).
When the transmission is at operating temperature (transmission oil temperature approx. 80 deg C) the display must be at the "max" mark for the correct oil level. |
||
| Correct oil if necessary | Re-check oil level once again. | ||
| Close locking lever (6a) and insert locking pin (6b) until it engages | Insert oil dipstick (6) so that the locking clip (6a) is easily accessible and does not contact anywhere. | ||
|
Torque Specifications |
| Torque Specifications | Nm |
| Drain Plug, torque converter |
14 |
| Drain Plug, oil pan (transmission 722.3, 722.4, 722.5) |
14 |
| Bolts, oil pan (transmission 722.0, 722.1) |
7 Bolts, oil pan (transmission 722.0, 722.1) |
| Bolts, oil pan (transmission 722.3, 722.4, 722.5) |
8 |
| Bolts, front axle crossmember (model 126) |
45 |
